|
The JRC NRD-545 is an exceptional DSP receiver that has a very extensive set of
features for casual shortwave listening and DXing. The SWL IR Remote is a
full-featured remote for the NRD-545 that gives enough control to make shortwave
listening a real pleasure. All front panel analog controls, including volume,
are controlled from the Universal Remote.
If you have the Wideband converter (CHE-199) installed, the SWL IR Remote will also
work in that frequency range.
Features
- Turn receiver on and off.
- Release and resume remote control to allow front panel operation and return to remote
operation.
- Enter frequency directly to 1Hz in the range of 100kHz to 30MHz.
- Enter frequency directly to 1Hz in the range of 30MHz to 1,999MHz with optional
Wideband converter (CHE-199).
- Increase or decrease frequency using CH +/- in steps of 1Hz, 10Hz, 100Hz, 1kHz,
5kHz, 9kHz, 10kHz, 100kHz, and 1MHz in the range of 100kHz to 30MHz; also 30MHz
to 1,999MHz with optional Wideband converter (CHE-199) installed.
- Set up to five (5) User Tuning Steps. Useful for detuning frequencies by one
half of filter bandwidth or use a very small frequency step to quickly zero-beat
in SSB mode.
- Recall last directly entered frequency.
- Directly select memory channels.
- Write VFO to memory.
- Move up and down through memory channels using CH +/-.
- Move memory frequency and mode to VFO.
- Write VFO frequency and mode to selected memory channel.
- Toggle between AM, AMS, LSB, USB, ECSS - LSB, ECSS - USB, and FM (configurable),
WFM (only above 30MHz) or CW (configurable).
- Select VFO or Memory mode.
- Control of Volume, RF Gain, Squelch, Noise Blanker, Notch, PBS, BWC, and Tone.
- Move analog controls to full CW, CCW, or default settings independently.
- Select Fast AGC, Slow AGC, or AGC off (configurable).
- Select Wide, Intermediate, or Narrow filter.
- Toggle RF Attenuation on or off.
- Toggle NB1, NB2, or off.
- Cycle through Tuning Rates (1Hz, 10Hz, or 100Hz). Frequency stepping operates
independently of selected Tuning Rate.
- Dim/Brighten display.
- Settable parameters:
- Enable/Disable FM and CW modes in mode selections.
- Enable/Disable AGC off in AGC selections.
- Enable/Disable Wideband converter operation.
- Frequency pacing. You can control the pacing of frequency up and down.
This is how fast the frequency changes when you hold the CH+/- keys.
- Define up to five User Tuning Steps.
- Status LED that shows communications status, normal position of RF Gain, Squelch,
Noise Blanker, Notch, PBS, and Tone controls, settable parameter entry, and clear
key operation.
|
